Moisture meters are for measuring the percentage of water on the surface of concrete, wood, metals, etc. We are supplying various types of normal and professional moisture meters.
One can easily and quickly detect in different materials near-surface moisture using our electronic moisture indicator BM31. This can be used as a wood moisture meter, concrete moisture meter, etc.
Also, it is possible to measure moisture distributions in ceilings, floors, and walls.
Moisture indication takes place in a totally non-destructive manner, due to the dielectric measurement method. No probes or electrodes need to be inserted into the material for measuring the moisture meter.
No delays are involved with the use of the moisture indicator model BM31, it works immediately. With fast response times, it helps the professional to check the moisture immediately. Helpful additional information is shown at just the push of a button. These values include current real-time measured values, and minimum and maximum values. The back-lit display is easily readable even during daylight. In addition, via the hold function, the momentarily measured value can be recorded.
The BM31 moisture indicator is not limited to only indicating various material moisture values that are on the surface. But in fact, it is particularly suited for the building materials’ readiness preliminary check for covering for CM measurements. The user can use the same meter as wood moisture meter, concrete moisture meter, cement moisture meter etc.
A few of the major functions of the moisture indicator model BM31 are listed below.
For the rapid, nondestructive determination of moisture distributions, this is a professional type hand-held moisture meter. It works in near-surface areas to about 4 cm.
The measurement results (indicative), based on the T660’s integrated material pre-selection function can be seen precisely in CM% or mass% on the moisture meter T660’s colour display. Measurement is possible for cementitious screed and anhydrite.
This moisture meter has a practical tool for the integrated conversion of measured values. This helps, in particular, to quickly check the readiness for covering floor layers. This moisture meter also can be used as a wood moisture meter, concrete moisture meter, cement moisture meter, etc.
According to the dielectric measurement method(indicative), the T660 is also suited for moisture measurements of non-destructive wood. Also, we can use it to check the building materials’ readiness and preliminary check for covering for CM measurements.
The T660, even in bright sunlight, ensures high-contrast presentation. It comes equipped with special display glass. It makes it easy to check the moisture distribution and quick detection in floor or wall areas along with the real-time, large-digit display.
It is Time saving and handy professional model. You can indicate a separate limit value in the T660’s settings prior to measuring. While measuring, if the value is above the limits it generates an audible warning signal.
This way, it can effectively and quickly measure large floor and wall areas. While measuring you may focus on the measuring object, without needing to keep an eye permanently on the displayed measuring results.
A few of the major features of the device are listed below.
Also, this model is ideal for measuring the material moisture measuring, for combined building diagnostics measurements.
The device comes with standard software. You can connect the meter through a USB connection. This provides an easy function for grid measurement creation.
In the Middle East, we serve the United Arab Emirates, the Kingdom of Saudi Arabia, Oman, Qatar, Bahrain, Iraq, Lebanon, Egypt, Jordan, Libya, Tunisia, etc.
In Africa, we serve countries including Kenya, Algeria, Tanzania, Djibouti, Chad, Ghana, Rwanda, Uganda, Nigeria, Ethiopia, Morocco, Angola, South Africa, etc.
Also, we supply to India, Bangladesh, Pakistan, Afghanistan, Kazakhstan, Srilanka, Maldives, and Cyprus.
This website uses cookies.